coordinate system. knowing that theta x = 32.5 , Fy = -60 N, and Fz >
0, determine Fx and Fz and the angles
STATICS AND STRENGTH OF MATERIALS
BMFG 1823
SEMESTER 1
SESI 2011/2012
Question 1
The airstroke actuator at D is used to apply a force of F on the member at B. The normal reaction of the smooth shaft at C on the member is 300 N. Determine the magnitude of F and the horizontal and vertical components of reaction at pin A.
[10 marks]
Question 2
The jib crane is supported by a pin at C and rod AB. If the load has a mass of 2 Mg with its center of mass located at G, determine the horizontal and vertical components of reaction at the pin C and the force developed in rod AB on the crane when x = 5 m.
[10 marks]
Page 2
ASSIGNMENT 2
FAKULTI KEJURUTERAAN PEMBUATAN
UNIVERSITI TEKNIKAL MALAYSIA MELAKA
STATICS AND STRENGTH OF MATERIALS
BMFG 1823
SEMESTER 1
SESI 2011/2012
Question 1
The airstroke actuator at D is used to apply a force of F on the member at B. The normal reaction of the smooth shaft at C on the member is 300 N. Determine the magnitude of F and the horizontal and vertical components of reaction at pin A.
[10 marks]
Question 2
The jib crane is supported by a pin at C and rod AB. If the load has a mass of 2 Mg with its center of mass located at G, determine the horizontal and vertical components of reaction at the pin C and the force developed in rod AB on the crane when x = 5 m.
[10 marks]
Page 2
ASSIGNMENT 2
FAKULTI KEJURUTERAAN PEMBUATAN
UNIVERSITI TEKNIKAL MALAYSIA MELAKA
ScholarMatic: Explanation & Answer
Your ready answer from a verified tutor is just a click away for as little as $14.99
Click Order Now to get 100% Original Answer Customized to your instructions!
