MIET2344-Assignment 1 MIET2344 ThermoFluids-2 Students should assign themselves to groups containing four people. Only one work is to be submitted by each group. Copying from another group is not permitted and will cancel the assignment mark of both the source and the duplicate. Deadline for submission of assignments is 5.00 p.m. on May 15, 2012. If an extension is required please see me in advance. Marks will be deducted for unauthorised late submissions. Each assignment is worth 15% of your final mark. The objective of this assignment is to foster an understanding of the flow in pipes, pump selection, drag, lift and their application in a “real life” situation. Assignment submission should contain the proper referencing. ASSIGNMENT Due Date: Tuesday 15 May, 2012 Q1. A certain part of cast iron piping of a water distribution system involves a parallel section. Both parallel pipes have a diameter of 30 cm, and the flow is fully turbulent. One of the branches (pipe A) is 1000 m long while the other branch (pipe B) is 3000 m long. If the flow rate through pipe A is 0.4 m3/s, (i) Determine the flow rate through pipe B. Discard minor losses and assume the water temperature to be 15 0C. (ii) Show that the flow is fully rough and thus the friction factor is independent of Reynolds number.
MIET2344-Assignment 2 Q2. The water at 20 0C in a 10-m-diameter, 2-m-high aboveground swimming pool is to be emptied by unplugging a 5-cm-diameter, 25-m-long horizontal plastic pipe attached to the bottom of the pool. Determine the initial rate of discharge of water through the pipe and the time (hours) it would take to empty the swimming pool completely assuming the entrance of the pipe is well-rounded with negligible loss. Take the friction factor of the pipe to be 0.022. Using the initial discharge velocity, check if this is a reasonable value for the friction factor. Q3 A pump is to be selected for a waterfall in a garden. The water collects in a pond at the bottom, and the…